Tool Box In A Carbon Pro

[pinebaron]

These turnbuckles look similar to ones I used to use for my ham radio antenna guy wires.

 

AT4 Forum Fav 👍

Air Lift 89388 LoadLifter 5000 Ultimate Plus Air Suspension Kit - Grab one through Amazon!

[wishywashy]

I believe the cargo hooks are 250 pounds each. I've no idea if that is rated for both horizontal and vertical loads, but I can't image you are creating more than a hundred pounds of net load unless you cranked those turnbuckles down like the hulk.

 

[mayday]

Just installed a tool box on my Carbon Pro - I went to lowes and grabbed some turnbuckles to tighten it down. Worked perfectly.

 

[ATexas4]

I just bought a slim craftsman toolbox from lowes, drilled holes in the slanted underside of the rail, and ran the J-hooks through those. The carbon fiber is a mat weave so its omnidirectional (wont lose strength with a hole in it) and no corrosion concerns.

Just be careful when you drill the holes because its a tough material that will catch your bit and spin your drill.