In bed ball sack mirror

[11Bravo]

Does the flag decal interfere with the slider? Worried about it peeling off. Never put them on moving glass before.

Mine has been on about 4 months. It was easy to apply and hasn't lifted (peeled) at all.

 

AT4 Forum Fav 👍

NOCO Boost Pro GB150 3000A UltraSafe Car Battery Jump Starter, 12V Battery Pack, Battery Booster, Jump Box0 - Grab one through Amazon!

[Clarkely]

what adhesive tape do they come with - what are temperature ranges for install? and how long at a warmer temperature for adhesive to cure - i got mine, itching to put them on and will be warmer today tomorrow, but cold at night

 

[gemarsh]

what adhesive tape do they come with - what are temperature ranges for install? and how long at a warmer temperature for adhesive to cure - i got mine, itching to put them on and will be warmer today tomorrow, but cold at night

I did mine on a rare 70° earlier this month. Then freezing after that.

It is one big piece of what looks like 3M double sided tape. Just didn't have the 3m logo. But there isn't a second chance to reposition.

 

[11Bravo]

I installed mine this weekend. The adhesive was very forgiving and I appreciated the clear plastic that covered the shiny face that I removed after the installation.

The temperature was a brisk 50 degrees, but it didn't affect the adhesive at all.

 

[Viking Truck]

But there isn't a second chance to reposition.

If you apply using the "wet" method you get plenty of second chances. Thoroughly wet the surface and the adhesive side of decal with water with a drop or two in dish detergent in it. The decal will slide around somewhat giving you the chance to get it perfect. Then with a dedicated squeegee press the water out and let dry. This is how I did my two layer decal on hood of Jeep and on a friends. Mine has been on 4 years, his probably 2 years and no negative affect on adhesion.

 

[gemarsh]

If you apply using the "wet" method you get plenty of second chances. Thoroughly wet the surface and the adhesive side of decal with water with a drop or two in dish detergent in it. The decal will slide around somewhat giving you the chance to get it perfect. Then with a dedicated squeegee press the water out and let dry. This is how I did my two layer decal on hood of Jeep and on a friends. Mine has been on 4 years, his probably 2 years and no negative affect on adhesion.

I use that method on tint, racing stickers and such. Never tried it with 3m 2 sided tape. I'll have to try it on some test material.

The wet method is boss...

 

[gemarsh]

I installed mine this weekend. The adhesive was very forgiving and I appreciated the clear plastic that covered the shiny face that I removed after the installation.

The temperature was a brisk 50 degrees, but it didn't affect the adhesive at all.

View attachment 35928

So you're not asking for a refund?

Looks way better than my Paintshop Pro rendition!

 

[Azgasser]

Had mine installed over the weekend. Easy and cut cleanly.