Back Up Camera View

[larryclements72]

Welcome.

Was you able to find out any way of fixing it or did you find out for sure if it was always like that

 

AT4 Forum Fav 👍

GM 3.0 Duramax Fuel system cap Magnetic Green - Grab one through Amazon!

[gemarsh]

I'm wondering if there is a way that we could shim up under the bottom of the camera to make it point up higher. Because looking at the picture in the reverse camera there's no way that's how it is all the time you can't even see hardly half a car behind you

Yeah, that's weird. You should see the horizon. Did you put a level kit on?

 

[larryclements72]

Yeah, that's weird. You should see the horizon. Did you put a level kit on?

View attachment 26933

No, but it's got a 8-in lift.

But I was just looking at it a little closer. I'm wondering since this tailgate has the split to it if it's not causing it to point towards the ground because the tailgate is not tilted tight like it should I think.

I always thought it was the screen that I replaced it with until I bought another one from a different company and it's the same way. So I'm going to look into it a little closer later today. I'm going to find out why it's so low like that

 

[gemarsh]

Split in the tailgate? You mean the multipro tailgate? Should not be an issue. I have 3 multipro tailgates and they all show the horizon.

I bet your 8 inch lift leveled out your truck, if not raising the front higher than the rear! Put a level on the bed rail and report back.

 

[larryclements72]

Yeah no it's definitely dead level. And the front camera would not be The same way. All the other cameras are good. It's just the front and the rear

 

[pinebaron]

I'm wondering if there is a way that we could shim up under the bottom of the camera to make it point up higher. Because looking at the picture in the reverse camera there's no way that's how it is all the time you can't even see hardly half a car behind you

If the view was any higher, it would miss a view of your hitch.