Anyone installed a DV8 off-road tube bumper? Now I have…

[john151ama]

After much noodling through the wiring schematics I have figured out I can grab high beam signal from circuit 311 or 711 anywhere between the LCM and the headlights.

For the backlights I think I will just grab an ignition switched source from anywhere since I want them on pretty much all the time, anyone know of a good ignition switched source in the main (engine bay) fuse block that I can tap?

Fuel pump is what I would go after.

 

AT4 Forum Fav 👍

K and N Engine Air Filter: Increase Power & Towing, Washable, Premium, Replacement Air Filter: Sierra 1500 - Grab one through Amazon!

[TX_Critter]

Got the bumper mounted and all the lights installed but only the fogs wired up so far, the relay block I ordered should arrive today so I can get the rest running… sorry no pics until then.

I’ll type up a long post with my full thoughts later, but for now I would not recommend this project for anyone with the 3.0 duramax unless you are VERY competent with modifying parts. I’m in contact with the DV8 tech team to hopefully get their installation instructions updated, but the entire lower air shutter assembly was not mentioned in the instructions so I had to hack it and it’s mounts up pretty badly to get the bumper to even fit.

Oh almost forgot, anyone need any stock front bumper parts in titanium rush?