With all that paint up front did you have paint protection film installed? On what areas? 3M film seems commonly used-are the other brands just as good? What price range should I expect?
Paint protection film
- Thread starter Steveo
- Start date
Lasllc
Active member
Did the entire front paint to include forward 12 inches of front fenders, except the black grill, all the light lenses, hood from front roll to 18 inches back, A pliers including the triangular bottom to 6 inches over the door, windshield top edge to sun roof forward, mirror paint, rear lower portions of the front and rear fenders above the stone guards and wrapped inward to cover the exposed areas, bottom 6 inches of all 4 doors above the factory bumpy “abrasion strip”. All 4 door sills , full length, from the AT4 step guard to just below the bottom of the door ; also added the black-red lettered “SIERRA” sill guards (amazon sourced), rear fender lower corners bottom to 6 inches up.
Ceramic tinting on the front side windows .
2500$ The guy was an artist with a trim blade. Z-PEL film (I think)
There’s a lot of gravel and rocks out here. We are off road a lot and the hiways we pull camper on have a lot of semis and trucks throwing stones. Especially those guys with 6 inch offset 38’s doing 90+. Not judging, just sayin.
I have owned and work on old aircraft; my machines dont look used. I take care of them and they take care of me
Rog
Ceramic tinting on the front side windows .
2500$ The guy was an artist with a trim blade. Z-PEL film (I think)
There’s a lot of gravel and rocks out here. We are off road a lot and the hiways we pull camper on have a lot of semis and trucks throwing stones. Especially those guys with 6 inch offset 38’s doing 90+. Not judging, just sayin.
I have owned and work on old aircraft; my machines dont look used. I take care of them and they take care of me
Rog
Duramaximus
Well-known member
What part of Utah are you from?
Lasllc
Active member
Ivins. About 8 nw of st george
