So I got to thinking and decided why should I buy a K&N or S&B air intake just for the noise when I can modify the stock air box. The K&N pulls air from the top and is actually pulling in hot air directly from the engine bay. The S&B pull air from the driver side and have a square plug that can be pulled for more air. So, I thought why not make a cut out like the side plug on the S&B air box and just have air get pulled through there while also providing more air/turbo noise. I even did an in garage air flow test with my blower and a sheet of plastic to verify that the air would flow directly to the air filter and not out the factory air duct. After the air flow test was completed I added mesh screening on the inside and outside of the air box with a filter from a shop vacuum in between the two mesh screens. This is to prevent minimal dust and debris from getting into the air box.
Now for added performance I add a CFT Intake pipe. I also intend to add a Stillen Air Scoop in the near future for more direct air flow into the air box.
Now for added performance I add a CFT Intake pipe. I also intend to add a Stillen Air Scoop in the near future for more direct air flow into the air box.