Leveling kit

tommy_21

New member
Joined
May 11, 2023
Messages
5
Media
1
Reaction score
3
Location
GA

Attachments

  • IMG_7539.webp
    IMG_7539.webp
    704 KB · Views: 434
Curious, I have a 2021 stock AT4 with the 20” rims. Considering putting a 1.75” level on the front. Did those 295s rub bad?
 

They definitely rubbed but it wasn’t that bad, but definitely required trimming or fender modifications for it to clear full turn. I can send you some close up pictures and explain what I did in further detail if you want. Also with the level you probably would have to run wheel spacers to clear the aftermarket upper control arms because my 295s are about 1/8 inch away from the stock ones
 

They definitely rubbed but it wasn’t that bad, but definitely required trimming or fender modifications for it to clear full turn. I can send you some close up pictures and explain what I did in further detail if you want. Also with the level you probably would have to run wheel spacers to clear the aftermarket upper control arms because my 295s are about 1/8 inch away from the stock ones
Did you end up putting the blocks back on the rear and doing the 1.75” level? I’d love to see how that turns out because I’ll probably be doing the same think. I think you’re certainly right about the spacers.
 

Did you end up putting the blocks back on the rear and doing the 1.75” level? I’d love to see how that turns out because I’ll probably be doing the same think. I think you’re certainly right about the spacers.
I haven’t, I think for now I’m going to leave it at least until it’s time for new tires then figure it out then
 

New Posts

Most reactions

Back
Top